Original Treadmill Motor Controller AL368 AL368AR for Conlin Kus EVERE Treadmill Motherboard Circuit board Control board

$135.32

Original Treadmill Motor Controller AL368 AL368AR for Conlin Kus EVERE Treadmill Motherboard Circuit board Control board

important：

1.Please send us a clear picture of the old controller before / after purchase so that we can check and verify it, especially for the replacement of the controller, to avoid possible incompatibility due to different models of the new controller, thus causes your loss, the trouble you, thanks!

2.Please purchase or need to replace the treadmill motor controller to ensure that the motor works normally. If you are not sure whether the motor works normally? (please see below for details on how to test, or please contact us)

Package include:

AL368AR originalwith incline / without incline controller *1PCS

warranty:3 months

How do you tell if your treadmill needs with incline or without incline?↓

1>As shown in figure above,with these two rectangular black components, it is a control board with incline function.↑

2>If there are no two black rectangular components, it is a control board without incline function

AL368AR↓

Controller type discrimination：

1 controller part number

2 incline sensor connector ( if available)

3 speed sensor connector ( if available)

4 display connector

5 transformer connector ( if availab）

6 incline motor connector ( if available)

7 IC chips part number ( if available)

How to determine whether the motor is working normally:

(if the motor works normally and the treadmill can not work, it is generally the motor control board fault and needs to be replaced, please contact us)

Error code troubleshooting（Below info for your reference.）：

E01: communication failure: console board and control board cannot communicate.probably console board issue or control board issue or data cable issue. replace a data cable,checking whether the machine can running? If no, Replace the control board.

E02 : control board or motor issue. Test the motor first to check if the motor can runing normally. If motor is normal, replace the control board.

E03 : 1,Turn on the treadmill , motor running a few seconds then stop and console board shows E03, probably the Speed sensor issue.

2,Turn on the treadmill,motor can't runing and console board shows E03, probably the control board issue .Test the motor first to check if the motor can runing normally. If motor is normal: 1,replace speed sensor; 2,replace control board

E04 : generally over-current fault:components of control board has burned. replace burned components or replace control board.

E05 :Current overload protection or Unstable speed.check the components on control board, if they connect normally? If not, re-plug the components or replace the control board.

E06 :Motor overload.Test the motor first to check if the motor can running normally. If motor is normal, replace the Current limiting resistor on control board or replace whole control board.

E07 :console board issue.replace console board cricuit board or replace data cable.

E08 :There may be a lift motor control fault.le)

Payment ways

Feedback